Passa al contenuto

Solution · Per-circuit monitoring

One number from the meter does not tell you which circuit spends it

The utility meter measures the whole house. rbAmp BASIC measures the groups you care about — water heater, kitchen, workshop, car charger — each on its own channel, on a controller you already own. Clip-on clamps: no break in the wiring.

What changes when every group has its own channel

You see the spender, not the total

A bill that grew tells you nothing about what grew. One channel per group names it: the water heater, the car, the workshop machine.

You see the standing load

The part that runs when nobody is home is invisible in a monthly total and obvious in a per-circuit graph.

You see it before the breaker does

A group that creeps towards its limit shows up as a curve, not as a trip on a Sunday evening.

What you need

One BASIC module per group of circuits, and a controller you already have.

  • Current channels: 1 to 7 per module (SCT-UI series — UI1, UI2, UI3, UI5, UI7), each with a voltage input, so a channel reports voltage, current and power, not just amps.
  • Your own SCT-013 clamps. You pick the rated current in software; the module is factory-calibrated for the SCT-013 family. How small a load a channel can resolve depends on the clamp's rating — the figures are per rating in the accuracy table on /products/basic.
  • Clip-on, not in-line. The clamp closes around the existing wire; nothing is cut and nothing is re-terminated. The module itself carries no mains circuit — all of it is low-voltage.
  • Several modules on one bus. Each module has its own address on I²C, so a panel with more groups than one module has channels is more modules, not another controller.

A worked panel

A common first build, and it is deliberately small:

  1. Pick the groups. Four is usually enough to answer the bill: water heater, kitchen, sockets, and the one load you suspect.
  2. Match the clamp to the group, not to the house. A 100 A clamp on a 10 A circuit wastes most of its range; the smallest rating above the group's real maximum reads that group best. The walk-through is under the accuracy table.
  3. One module, one controller. A four-channel module on an ESP32 covers all four groups and leaves the controller free for everything else on the bus.
  4. Grow by adding modules, not by starting over. The fifth group is another channel on the next module, same bus, same code.

Modules in the shop → · Ready-made kits →

And when one panel is not the whole story

Several cabinets, or several buildings, mean several controllers today — each one complete, each one reporting on its own. A single synchronized view across them is what the RBgrid hub is for, and it is in development.

Read before you buy

Find out which circuit it is.

Start with one module and the groups you already suspect. The configurator sizes it; the docs get the first reading on the bench.