rbAmp
EN
Shop

Not sure which rbAmp you need? Answer four questions or draw your panel

Two lines, several clamp ratings and two clamp types. Start from what you want to see, and you get the parts list.

The choice applies per point, not per house: STD where the number must be right, BASIC on the branches you only want to see. Add later, never replace.

BASIC — monitor

Live V · I · P; energy added up on your controller.

Consumption only, lowest cost per circuit.

I-series SCT-I1 / I2 / I3: live current for control.

Interface: I²C. Needs a controller (ESP32, Arduino, Raspberry Pi).

STD — account

Counters on the device, saved every second.

Import and export separately; very small loads resolved.

Interfaces: I²C, or Modbus RTU over UART TTL with an external RS-485 transceiver.

Works standalone as a Modbus meter, or on the same I²C bus as BASIC.

BASICSTD
RoleMeasureMeasure & Meter
Energy on the deviceno (master computes)yes, counters saved every second
Direction (import/export)consumption onlyyes, two counters
InterfacesI²CI²C, or Modbus RTU (ext. RS-485)
Phases1 per module1 or 3
Sensoryour SCT-013 clampin the kit, calibrated and labelled
Standaloneno (needs a master)yes (Modbus RTU, ext. RS-485)
TrustSCT-013 characteristics per ratingevent log, device certificate, signed records, signed firmware
Buildopenopen, DIN-clip enclosure

Watching the house

BASIC modules + SCT-013 clamps

Home with solar

STD-UI1 + BASIC branches

Three-phase input

STD-U3I3

Meter for an inverter

STD-UI1 + external RS-485 transceiver

Workshop sub-metering

STD-U3I3: energy counters per channel

If you want a finished app rather than modules to build with, see RBgrid — a local energy app on a hub in your panel that shows what every measured circuit costs.