Yes — and the reason is the architecture, not a barrier bolted on: the module itself is all low-voltage.
Current is measured with a clamp that closes around the outside of the insulated conductor — magnetic coupling only, so nothing at line potential enters the module. The UI variants have exactly one mains reference, the L–N voltage sense, and it goes through a galvanically isolated divider; the ampere-only variants have no mains connection at all. Your GND is the host's ground, not mains neutral, so wiring the I2C side to an Arduino or an ESP32 is safe. Don't open the enclosure — it voids the factory calibration.
FAQ · · 1 min read
Is the rbAmp module isolated from mains?
Yes — the module is all low-voltage: the clamp reads the conductor from outside, and the UI variants' single mains reference goes through an isolated divider.